Brake cable tension is adjusted at the anchor nut (A) so that
each brake pad maintains a distance of 1.5 mm to the rim.
If an adjustment needs to be made, the protruding wire end
should then be refastened to the brake.
Scope of deliver
• Balance bike
• Handlebar
65
m
m
5-8 Nm
!
60
m
m
!
10 Nm
Insert the handlebar into the steer tube and tighten the screw.
Please pay attention to the marking of the minimum insertion
depth.
After loosening the saddle clamp, you can pull out the saddle
(observe minimum insertion depth!). Then retighten (5-8 Nm).
1
2
Settings control and fine adjustment of the brake
(V-brake). Only for model LR XL.
ca. 60 mm
1
1
1 mm
Make sure that the brake pads are parallel to each other and
that they are properly aligned with the rim. This means that
the brake pads should rest 1 mm below the top edge of the
rim. If these settings are not correct, loosen the fastening
nut of the brake pad (1) and align as described above. To
do so, pull the brake lever and re-tighten the fastening nut
(5-8 Nm).
1,5 mm
1,5 mm
A
!
10NM
60mm
65mm
5-8NM
5-8NM
