PUKY GmbH & Co. KG
Fortunastraße 11 D-42489 Wülfrath [email protected] www.rukybikes.com
Subject to alterations
Art. Nr. 43831
04.2019/V1
1
1
_
+
+
_
_
+
Now centre the brake arms by turning the adjusting screw. You will need a crosstip screwdriver for this. It is important that
the brake levers are actuated several times so that the tension of the brake arms is evenly distributed to both sides and the
settings take effect. The brake/rim contact must be identical on both sides.
................
................
................
VEHICLE PASSPORT
Please complete the information from the type label
so that you have all the information you need in the
event of any questions or when ordering spare parts.
Type label
Brake cable tension is adjusted at the anchor
nut (A) so that each brake pad maintains a distance of
1.5 mm to the rim. If an adjustment needs to be made,
the protruding wire end should then be refastened
to the brake.
Settings control and fine
adjustment of the brake
(V-brake). Only for model LR Light BR.
ca. 60 mm
1
1
1 mm
Make sure that the brake pads are parallel to each other
and that they are properly aligned with the rim. This means
that the brake pads should rest 1 mm below the top edge
of the rim. If these settings are not correct, loosen the
fastening nut of the brake pad (1) and align as described
above. To do so, pull the brake lever and re-tighten the
fastening nut (5-8 Nm).
1,5 mm
1,5 mm
A
!
5-8NM
