Manual
RUKRA GSM/PSTN Interface_ENG_V1
Article number: RK-1201
4
Programming procedure with the USB interface:
the RUKRA GSM / PSTN interface can be programmed with a computer and the
necessary software "GGSET" and the USB interface. The USB interface is connneted
with a 6 conductor flat cable to the RUKRA GSM / PSTN interface. Parameters that
are programmed with an attached phone can also be programmed with the PC
except the PIN code of the SIM card.
Phone numbers for SMS messages can only be programmed with a computer using
the "GGSET" program and the USB Interface.
Programming can be with or without the presence of a SIM card.
On the website www.rukra.eu you can download the required software and the
manual "Configuration software for RUKRA GSM / PSTN interface"
USB Interface:
You can control RUKRA GSM/PSTN interface directly via the USB Interface. The
RUKRA GSM/PSTN interface can further be used like an ordinary GSM modem for
data transmission, internet connection or for SMS messages. When the RUKRA
GSM/PSTN interface is working as GSM modem then it is busy for voice connection.
When you pick up the line you will hear busy tone. The RUKRA GSM/PSTN interface
is monitoring data transmission by modem. The data transmission can not be
permanent therefore the RUKRA GSM/PSTN interface stays in data mode 10
seconds after finishing of data transmission. Then is going back to Voice mode
(calling). The same is when you are calling over RUKRA GSM/PSTN interface. It is
busy for data transmission. The optional software supply to unit for sending and
receiving SMS messages is SMS mail. It is working under Outlook and you can work with SMS as with normal e mails.
It works in batches and allows programm communication interval (1 to 99 minutes) to RUKRA GSM/PSTN interface
for sending and receiving SMS. Due this we avoid situation that the RUKRA GSM/PSTN interface is permanentlky
blocked by data mode for voice communication. Further functionality of USB is monitoring RUKRA GSM/PSTN
interface operation. It is possible record even incoming calls includes time and CLIP, signal strength, etc..