Hardware Installation and Reference Guide
Installing the Access Point
3.
If the AP is installed on the ceiling, hold the AP in your hands and push it sideward. And attempt to push it along the
direction of the LAN port.
Figure 3-11 Removing the Ceiling-Mount AP
3.7
Connecting Cables
Connect UTP/STP to the LAN1/PoE port on the AP. See Appendix A for supported wiring of twisted pairs.
By default, baud rate is set to 9600, data bit 8, parity none, stop bits 1 and flow control none on the console port of
the AP. The console port is used only when you want to configure the AP manually. In this case, you need an
RJ45-to-USB conversion module and a USB-to-micro-USB conversion cable.
The conversion module and the conversion cable are customer supplied.
3.8
Bundling Cables
Precautions
