Ruijie RG-AP220 Series, Быстрое руководство по установке

Страница: 8 / 10

Fig 4.
1.2.2 Adapter Power Supply
When using adapter power supply, please use the adapter recommend by our company.
1.2.3 Check Power-on Status
After the AP is powered, if the device works normally, the STATUS LED will blink green,
and then stop blinking after 30 seconds (see 2 in Fig. 5). The RADIO LED will light up
green when AP works at 2.4G (see 1 and 3 in Fig. 5). When the Gigabit Ethernet cable is
connected to the Ethernet interface of AP, the LED will light up or blink (green for 1000M,
orange for 100M/10M, constant green for link only, and blinking for data transmission).
Fig 5.
1.2.4 Troubleshooting
1. The status LED won't light up after power-on
A. POE power supply: please check and make sure the other end of cable has 802.11af
power supply enabled, and then check whether the cable is properly connected.
B. Adapt power supply: Check whether the adapter has commercial power input, and then
check whether the adapter works normally.
2. After connecting the Ethernet cable, the Ethernet indicator LED won't light up or blink
Please check whether the counterpart device works normally, and then check whether the
Ethernet cable is applicable for the current data rate. Make sure the cable is properly
connected.