Ruijie Reyee RG-EST Series, Руководство по настройке

Страница: 28 / 38

Web-based Configuration Guide Alarm and Fault Diagnosis
5.1.3 Default WDS Password Is Still Used by All Devices
The default WDS password of devices of the same model is the same. Changing the WDS password can prevent
others from illegally accessing the network by using a device of the same model.
Click Click here to configure WDS Password , enter the new password, and click Save to change the WDS
password for the entire network.
Caution
When configuring the WDS password for the entire network, ensure that all devices are online. Otherwise,
WDS passwords of the devices will be inconsistent.
Configuring the WDS password for the entire network will reconnect all devices in the network. Therefore,
exercise caution when performing this operation.
If there is an unbridged device in the network, the function of configuring the WDS password for the entire
network will be disabled.
5.1.4 Network Cable Is Disconnected or Incorrectly Connected
Hover the cursor over the orange number of the prompt to display the alarm details.
Click the suggested action to check the solution.
5.1.5 Latency Is High or Bandwidth Is Insufficient
First, check whether the device latency is too high. If yes, the interference in the environment may be severe.
Then, you are advised to change to a channel with smaller interference.
If not, increase the channel width. For channel settings, see Channel settings . For channel width settings, see
Optimizing the Channel Width .
To check whether the latency is too high, perform as follows:
Hover the cursor over the orange number of the prompt to display all WDS groups, and click a group to display
the details.
On the Overview page, check whether Latency is Freeze . If so, the latency is too high. Otherwise, the latency
is normal.