Hardware Installation and Reference Guide
Product Installation
During installation, please note the following points:
Ensure the wall or ceiling where the power adapter to be installed is dry enough and watertight.
Keep the power adapter away from heat sources, electromagnetic radiation areas, power lines, inflammables and
explosives.
Make sure the 4 pairs of cables connected to the PoE input port in the RG-PBOX are of fine quality, for the
maximum output of the power adapter. Cat5e cables and those of high specifications are top choices.
Ensure that the RG-PBOX to be installed works properly.
Identify the positive and negative ends of the DC-powered IP device.
Make sure the power supply is properly connected.
Don’t put heavy items on the power adapter.
Ensure that the chassis should be mounted in a place with sufficient space(10cm at least) for air circulation. Don
’
t
pile power adapters.
Avoid direct sunlight. Keep the device away from high-power radio transmitter, radar transmitting station, and
high-frequency large-current device. Measures must be taken to isolate static electricity. For example, use a
shielded cable as the interface cable.
3.3.1 Wall Mounting
1)
Take out the mounting bracket and expansion screws (M4*10). And install the bracket as shown in the following
figure.
Figure 3-1 Install the Mounting Bracket
2)
Place the power adapter at the desired position and make marks for the screw holes on the wall. Remove the
power adapter, drill holes at the marks using the hammer drill, align the screw holes of the power adapter with the
holes on the wall, tap wall anchors into the holes, and drive expansion screws (M4*20) through the power adapter
into the anchors to fix the bracket. See the following figure.
Figure 3-2 Installing the Power Adapter
