4-17
WS6008(config-ac)#strict-limit response-rssi
Note:
The AP530-I v1.0 does not support the coverage area configuration.
Q2: Switching Internal and External Antennas
1.
Enable external antennas (internal antennas are enabled by default).
FAP MODE: interface Dot11radio1/0
External-antenna enable
FIT MODE: ap-config xxx
External-antenna enable radio 1
2.
Enable internal antennas.
FAP MODE: interface Dot11radio1/0
No external-antenna enable
FIT MODE: ap-config xxx
No external-antenna enable radio 1
Q3: Description of Transmit Power of AP Antennas
Run the show dot11 wireless 1/0 command. In the displayed information, actual Tx Power and Max Txpwr Limit indicate the
actual transmit power and maximum transmit power of the AP respectively.
The actual transmit power of the AP is greater than the power specified in the product description, so as to meet coverage and
performance requirements.
Use the AP630 as an example. The output of the show dot11 wireless 1/0 command indicates that the maximum transmit
power is 32 dBm, whereas the maximum transmit power specified in the product description is 27 dBm.
Q4: The RF Port on the AP520-I of Version B5 Is Up and Down Frequently
