When the unit is first powered on, the Welcome screen is displayed followed shortly by
the Main Interface screen.
1.6.1 Fast Voltage and Current Setting
Press
key to enter the fast Voltage setting mode. Press the rotary control to cycle
through the characters available, place the cursor at the required character, turn the rotary
control clockwise increases the value and anticlockwise decreases the value. Press
key
to save the data and exit, alternatively, after 1 minute of inactivity the setting mode will exit
automatically. Press
key to set the output Current
limit
using the same procedure.
1.6.2 Advanced Parameter Setting
In the main interface press the
key to enter the Data Setting Interface. In the Data
Setting Interface press
key or
key to step up or down through the menu options
to select
(Voltage) or
(Current Limit),and then set the output Voltage and
output Current Limit in the same way as used in the main interface.
1.6.2.1 Protection Values Setting
Switch to
(Over-Voltage Protection),
(Over-Current Protection) or
(Over-Power Protection) limits. We can set the value of Over-Voltage protection
value, Over-Current protection value and Over-Power protection value. When any of the
protection value limits are reached ,the output will be automatically disabled, and there will
be
displayed on the interface; When the temperature of Power board exceeds
80
℃
,the output will be automatically disabled, and there will be
displayed on the
interface. Press the rotary control to place the cursor at the required character, and turn the
rotary control to set the value. Press
key to exit.
1.6.2.2 Screen Brightness Setting
Switch to
, press the rotary control to select the character you want to change.
Turn the rotary control to adjust the brightness from 0 to 5 where 0 is the darkest and 5 is
the brightest. Press
key to exit. It’s up to you to set the brightness you like.
1.6.2.3 Data Settings and Saving In Specified Data Group
Switch to
,press the rotary control to select
Data Group Number, press
key
and then press
key or
key to
step up or down through the menu options, press
the
rotary control to set the value you need. Press
key for over 2 seconds and the data will
