Appendix D. Console Connector Specifications
RuggedMAX™
36
Installation Guide Rev 1.0
Appendix D. Console Connector Specifications
The Console connector should be closed in normal conditions and is only intended for
the use of an authorized technician.
The chassis has an RJ-45 maintenance female connector, used by a technician to connect a
“console”.
The port is used by maintenance personnel to communicate with the processor when the normal
management interfaces cannot be used. The console port is based on the RS-232 serial standard
and supports a standard terminal connection.
The Console port enables the technician to configure and monitor the WiN7200 Small Form Factor
Base Station unit through a CLI (Command Line Interface) for low level debugging.
The following table describes the console connector pinout.
Pin Number
Type
1
TX
2
RX
5
GND
Table D.1. Console Connector Pinout
The serial cable used to connect the WiN7200 Small Form Factor Base Station Console port to
the console is supplied by .
• Cable Type: Cat5
• Cable Connectors: DB9F; RJ45
• Cable Length: 2m
