Ruckus Wireless ZoneFlex series, Руководство по установке

Страница: 43 / 68

37
Preparing the 7781CM at the Depot and Shipping to the Field
Verifying AP Operation
Associating a Wireless Client with the AP
1. In the client device's wireless interface, select the SSID configured in “Configuring
Wireless # Settings” on page 33.
2. Connect the client device to the selected WLAN SSID.
After the wireless client successfully connects to the wireless LAN, continue with “Checking
the TR069 Status (FlexMaster Management Only)” on page 37 or “Disconnecting the AP
from the Power Source and Administrative Computer” on page 38.
Checking the TR069 Status (FlexMaster Management
Only)
If you configured the AP to report to a FlexMaster server on the network ( “Setting the
FlexMaster Server Address (Optional)” on page 34), then make sure you verify that the AP
can successfully communicate with the FlexMaster server. You can do this by checking the
TR069 status on the AP’s web interface.
1. In the AP’s web interface, go to the Administration > Management page.
2. Scroll down to the TR069 Status section.
3. Check the value for Last successful contact . If it shows a date in green, then the AP
was able to communicate successfully with FlexMaster.
Continue with “Disconnecting the AP from the Power Source and Administrative
Computer” on page 38.