Copyright © 2015 Ruckus Wireless, Inc.
Page 4 of 4
Published 24 July 2015, Part Number 800-70972-001 Rev A
Removing the AP from the Optional Secure
Mounting Bracket
A
Gently press the unit removal pin (A in
on the end of the AP to release the bracket locking tab in the upper
keyhole.
Figure 8. Removing the AP from the secure mounting bracket
B
Slide the AP toward the unit removal pin and remove the AP from the
bracket.
T
ROUBLESHOOTING
•
CAUTION:
If required, you can reset the AP to its factory default
settings by using a straightened paper clip to press and hold the reset
button located between the
POE IN
and
12VDC
ports, for six or
more seconds. DO NOT DO THIS UNLESS SO INSTRUCTED. (Doing this
resets the AP IP address to 192.168.0.1.)
•
NOTE:
After a reset, you can access the internal AP web interface
using
https://192.168.0.1
. Your device must use any other
unused address from 192.168.0.2 through 192.168.0.254, with
subnet mask 255.255.255.0. The username is
super
, and the
password is
sp-admin
. Refer to the
Ruckus Wireless Indoor AP User
Guide
for information on configuring and operating the AP. This
document is available at
https://support.ruckuswireless.com
Mounting Template:
A
82.6mm
3.25in
