Installing the Access Point
Verifying the Connection
ZoneFlex P300 Wireless Bridge User Guide, 800-70956-001 Rev B
24
4
In the
Configuration > Radio 5G > Advanced
page, select the approximate
distance between the root bridge and non-root bridges from the
Distance
drop-
down menu. (Default=3km.)
5
Click
Update Settings
to confirm your changes.
After you have set the distance between the root bridge and non-root bridges,
continue with
.
Verifying the Connection
Once you have completed the hardware installation and aiming procedure for all
ZoneFlex P300s, verify the connection and signal integrity between a root bridge
and non-root bridge pair using the following procedure:
1
If not already done, log into the root bridge Web interface as described in
Into the ZoneFlex P300 Web Interface
2
Navigate to
Status > Wireless
. On the
Status > Wireless
page, make sure that
the non-root bridge is listed in the
Connected Devices
section.
Figure 11. Viewing connected devices from the Web interface
3
On the
Status > Wireless
page, click the SpeedFlex icon
to launch the
SpeedFlex Wireless Performance Test.
4
Click
Start
to begin testing.
5
Once the test is completed, the following result page is displayed.
