Copyright © 2013 Ruckus Wireless, Inc.
Page 3 of 4
Published November 2013, Part Number 800-70590-001 Rev A
Verifying the Installation
1
Using any wireless-enabled computer or mobile device,
search for and select the wireless network you previously
configured.
2
If you can connect, open a browser and link to any public
Web site.
Congratulations!
Your wireless network is active and ready
for use. If you need to configure advanced wireless settings,
such as enabling security, see the ZoneFlex AP User Guide.
S
TEP
2: O
PTIONALLY
M
OUNTING
THE
AP
ON
A
W
ALL
, C
EILING
OR
T-B
AR
The ZoneFlex 7321 can be mounted to a wall, ceiling or to a
T-bar using the supplied mounting screws or the T-bar clips
built into the bottom of the AP enclosure.
Continue with the following:
•
Mounting on a Flat Surface
•
Mounting on a T-Bar
Mounting on a Flat Surface
1
Collect the following required tools:
•
Drill with 5mm drill bit
•
Screwdriver set
•
Thin metal probe or straightened paper clip
2
Use the template on the last page of this
Quick Start
Guide
to mark the locations for screw holes on the
mounting surface. Use a 5mm drill bit to drill
approximately 25mm into the mounting surface.
3
Insert the anchors and mounting screws into the
mounting surface, leaving approximately 6mm (0.25”) of
the screw heads protruding for the AP enclosure.
The screws should be approximately 82.6mm (3.25”)
apart per the template.
4
Insert a probe (or a straightened paper clip) into the hole
on the side of the AP and hold it in to release the locking
mechanism (A in
Figure 3
).
Figure 3. Insert a paper clip into the pinhole
5
Place the AP onto the mounting screws so that the screw
heads enter the mounting holes on the AP enclosure,
and push the AP (to the left or down depending on
orientation) to lock in place.
6
Remove the probe to release the lock mechanism and
secure the AP.
7
To unmount, insert a probe into the hole on the side of
the AP and hold to unlock, then push the AP (to the right
or up, depending on orientation) to release the AP
enclosure from the mounting screws.
Mounting on a T-Bar
1
Collect the following required tool:
•
Torx T8 tamper proof security screwdriver
2
Orient the AP so that the T-bar is positioned between
the T-bar clips as shown in
Figure 4
, then rotate the AP
until the third T-bar clip catches the T-bar and the latch
locks the T-bar in place (
Figure 5
).
Figure 4. Initial position
Figure 5. Final position
3
Insert the security screw into the hole near the latch to
lock in place.
4
To remove the unit, first remove the security screw, then
depress the latch while rotating the AP so that the T-bar
clips disengage the T-bar.
A
