Ruckus Wireless T504, Руководство по установке

Страница: 26 / 48

Installing the T504
Deploying the T504
T504 Strand Mount Concurrent AP with Integrated CM Installation Guide, 800-70610-001 Rev A
27
Windows saves the IP address settings that you have configured.
Operating the CM
In addition to the T504 AP command line interface (CLI) and web interface, the CM
part of the T504 also has web and CLI interfaces. With these interfaces, you can
operate the CM part. Refer to the following sections:
NOTE The cable modem and access point each has its own independent firmware
load that is updated independently.
• About the CM Command Line and Web Interfaces
• Logging Into the CM Web Interface from the T504 Ethernet Port
• Logging Into the CM Web Interface using a Dynamic IP Address
• Viewing the Software Status
• Viewing the Connection Status
• Configuring the Downstream Frequency
• Administering Cable Modem Passwords
• Viewing the SNMP Event Log
About the CM Command Line and Web Interfaces
The CM command line interface is similar to the AP CLI, and is used for CM-specific
operations. You can perform most CM operating tasks from the CM web interface.
Logging Into the CM Web Interface from the T504 Ethernet Port
1 Collect required equipment and information:
• The IP address assigned to the CM by the CMTS DHCP server.
• An administrative computer as configured as described in Preparing the
Administrative Computer .
• One Cat5e or better Ethernet cable.
2 Use a 7/16” (11mm) wrench to remove the reset button and diagnostic Ethernet
port screw-in plug (see
Figure 5 ).
3 Connect one end of an Ethernet cable to the Ethernet port on the T504, and
then connect the other end to the administrative computer’s Ethernet port.
4 On the administrative computer, open a web browser window.
DRAFT