Copyright © 2017 Ruckus Wireless, Inc.
Published July 2017, Part Number 800-71482-001 Rev A
Page 3 of 3
CAUTION:
The T310d AP includes one 9mm stainless steel M6x1
earth ground screw with split lock and flat washers. Make sure
that any replacement screw is no longer than 9mm. If a screw is
longer than 9mm, it can damage the AP chassis.
Figure 9:
Connect good earth ground to AP here
Congratulations! You have mounted your T310d access point.
I
NSTALLING
A
USB D
ONGLE
To install a USB dongle, which could be an IoT radio like BLE,
802.15.4, Z-wave or the like, remove the two 3mm hex screws,
remove the cap, and insert the dongle into the USB port. Once
installed, replace the cap and the hex screws, and torque the screws
to 7 in-lbs.
NOTE
:
The maximum dimensions of the USB dongle that can be
inserted are xxx. If you need to install a larger USB device, you can
purchase a separate USB cover, part number xxx.
Figure 10:
Installing a USB dongle
T
ROUBLESHOOTING
CAUTION:
If required, you can reset the AP to its factory default
settings by pressing the reset button located inside the PoE IN
port. DO NOT DO THIS UNLESS SO INSTRUCTED. (Doing this
resets the AP IP address to 192.168.0.1.)
NOTE:
After a reset, you can access the internal AP web interface
using
https://192.168.0.1
. Your device must use any
other address from 192.168.0.2 through 192.168.0.254, with
subnet mask 255.255.255.0. The username is
super
, and the
password is
sp-admin
. Refer to the Outdoor Access Point User
Guide for information on configuring and operating the AP. This
document is available at
https://support.ruckuswireless.com
.
NOTE:
After an AP is removed from its mounting, it may drip
some water from the channel surrounding the radome. As long as
the AP has been operating normally, this incidental water
collection and dripping is normal, and is not service-affecting.
