Ruckus Wireless R610, Быстрая настройка

Страница: 3 / 4

Copyright © 2017 Ruckus Wireless, Inc.
Page 3 of 4
Published September 2017, Part Number 800-71495-001 Rev C
Mounting on a Recessed Drop-Ceiling T-Bar
The enclosed T-bar bracket supports mounting to recessed
drop ceiling T-bars.
•
Mounting an AP using the External Bracket
•
Removing an External Bracket from a T-Bar
•
Removing the External Bracket from the AP
Mounting an AP using the External Bracket
1 Position the studs on the bottom of the T-bar bracket (B
in
Figure 9
) in the mounting holes on the R610 enclosure,
and then slide the T-bar bracket until the studs are in the
narrow parts of the R610 mounting keyholes.The mount-
ing bracket locks in place on the AP enclosure.
Figure 9. Attaching the external bracket to the AP
2 Attach the locking tab (C in
Figure 9
) to one side of the T-
bar and the bracket (B in
Figure 9
) to the other side of the
T-bar.
3 Slide the locking tab (C) into the bracket (B) so that it
locks in place around the T-bar (
Figure 10
). Make sure that
both clasps are gripping the T-bar.
Figure 10. Attaching the external bracket to the T-bar
Removing an External Bracket from a T-Bar
1 Move the ceiling tiles out of the way.
2 Slide the locking tab away from the T-bar to release
the AP-bracket assembly from the T-bar.
3 The R610-and-T-bar bracket assembly comes away
from the T-bar.
Figure 11. Removing the external bracket from the T-bar
Removing the External Bracket from the AP
1 Insert the unit removal pin into the hole on the front of
the AP to unlock the mounting bracket from the AP
enclosure.
2
Slide the mounting bracket (
Figure 12
) toward the
Ethernet ports on the R610 until it detaches from the
R610.
Figure 12. Removing the external bracket from an AP
Mounting on a Flush Drop-Ceiling T-Bar
Mounting an AP using the Integrated T-bar clips
1 Orient the AP so that the T-bar is positioned between
the T-bar clips as shown in
Figure 13
, then rotate the AP
until the third T-bar clip catches the T-bar and the
latch locks the T-bar in place (
Figure 14
).
Figure 13. Attaching the AP to the T-bar
Figure 14. Locking the AP to the T-bar
2 Insert the Torx security screw into the hole near the
latch to lock the AP in place.
Removing an AP Integrated Bracket from a T-Bar
1 To remove the AP from a T-bar, first remove the
security screw, then depress the latch while rotating
the AP so that the T-bar clips disengage the T-bar.
Mounting on a Truss or Pole
1 Feed the customer-supplied cable ties through the
four slots on the back of the R610.
Figure 15 Cable tie slots
2 Fasten the R610 to the truss or pole using the cable
ties.
Note:
This mounting bracket can also be used on a flush
drop-ceiling T-bar, so the four rubber feet on the
bottom of the AP minimize ceiling tile displacement.
Note:
The built-in mounting clips on the bottom of the
AP are designed to accommodate 15/16 T-bar widths
only.