Ruckus ICX 7850 Switch Hardware Installation Guide
31
Part Number: 53-1005580-01
Mounting the Device
Installing the 1U, 1.5U, and 2U Universal Kit for Four-Post Racks (XBR-R000295)
Attaching the Front Brackets to the Rear of the Device
NOTE
In this installation, the brackets are named as listed in the parts list even though the installation of the brackets is reversed from
the flush-front installation.
Complete the following steps to attach the front brackets to the rear of the device.
1.
Position the right front bracket with the flat side against the right rear side of the device, as shown in
2.
Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then into the holes on the side
of the device. Use the upper and lower screw holes, leaving the center holes empty.
3.
Repeat Step 1 and Step 2 to attach the left rear bracket to the left side of the device.
4.
Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 22
Attaching the Front Brackets to the Rear of the Device
Attaching the Extensions to the Front of the Device
Complete the following steps to attach the extension brackets to the front of the device. There are medium and long extension brackets
that you can use for this step. Choose the correct extension for the depth of your rack.
1.
Position the right extension along the side of the device as shown in
.
2.
Attach the bracket using four 8-32 x 5/16-in. flathead screws.
3.
Repeat Step 1 and Step 2 to attach the left front extension to the left side of the device.
1
Device
3
Screws, 8-32 x 5/16-in., flathead Phillips
2
Front brackets
