44
Ruckus ICX 7450 Switch Hardware Installation Guide
Part Number: 53-1003899-07
Installing the Ruckus ICX 7450
Installing the Universal Four-Post Rack Kit (XBR-R000296)
1.
Select the proper length extension bracket for your rack depth.
2.
Position the right extension bracket along the side of the device as shown in
.
3.
Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the extension bracket and then into the holes
on the side of the device. Use the upper and lower screw holes, leaving the center holes empty.
4.
Repeat Step 1 and Step 2 to attach the left extension bracket to the left side of the device.
5.
Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 33
Attaching the extension brackets to the device
Installing the device in the rack
Complete the following steps to install the device in the rack.
1.
Position the device in the rack, as shown in
, providing temporary support under the device until the rail kit is secured to
the rack.
2.
Attach the right front bracket to the right front rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use
the upper and lower holes in the bracket.
3.
Attach the left front bracket to the left front rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
4.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
1
Extension brackets
2
Screws, 8-32 x 5/16-in., flathead Phillips
