RUCELF SDF Series, Инструкция по эксплуатации

Страница: 36 / 40

36
eng
8. Setting-up procedures
ATTENTION! Make the external examination to be sure there are no mechanical
damages.
If transportation was made at subzero temperatures, please keep
the device not less than 2 hours at a room temperature for the prevention of
condensation.
ATTENTION! Only person, who have studied this instruction can work with the
device.
• Unpack the stabilizer and look if there are no case and automatic switch
defects
• Set the stabilizer in the suitable room
• Ground the case of stabilizer
• Before connection make sure, the automatic switch is in the «Выкл.»
position
• Connect the load to the stabilizer’s clamps
• Connect the input voltage to the stabilizer’s clamps
• Connection the power cord to 220 V
• Se the automatic switch in the «Выкл.» position
• You will see the green LEDs on the front panel, and in 5 sec the stabilizer
will activate the output voltage
• During pushing and holding the «Input voltage» «Входное напряжение»
button, you can see the value of input voltage on the display. During release
of this button, the stabilizer will show the output voltage
ATTENTION!
The input stabilizer voltage more than 280V can be the reason of damage.
If you plan to use the stabilizer in the high voltage networks, please install the
power-disconnection device during achievement of the rated voltage values.