14 — English
INSTALLING THE WATER TRAY FRAME
ASSEMBLY TO THE LEG STAND
See Figure 7.
Lock the table stop by-pass by pulling up on the stop
and turning it until the slot in the center of the lock is
horizontal (left to right).
To lock sliding table:
Pull the sliding table to the front
of the frame. From under the right side of the table, align
the hole in the rail with the pin in the sliding table lock
lever. Push the pin into the rail locking the table.
Slide the tubes on the water tray frame assembly into the
tubes on the leg stand.
Insert short carriage bolts into holes and tighten securely
using lock nuts.
INSTALLING MOTOR HEAD ASSEMBLY TO
WATER TRAY FRAME
See Figure 8.
Align the holes in the motor head assembly with the holes
on the side of the water tray frame.
Insert short cap bolts. Finger tighten using nuts.
Slide long cap bolts into sleeve. Insert into holes. Finger
tighten.
Tighten all cap bolts using an 8 mm hex key.
INSTALLING CLEAR TUBES AND WATER PUMP
TO THE SAW
See Figure 9.
Push the end of the short clear tube over the left
connector.
Slip the tube onto the valve assembly in the saw arm by
pushing the tube over the connector. S Attach the clear
tube to leg stand using the tube clips on top of the leg
stand.
Connect the long clear tube by pushing the tube over the
connector.
Fill the water tank two-thirds full.
Center the water tank on the lower brace of the leg stand
and push the tank firmly against the center brace until it
locks into place.
Push clear tube over the leg stand.
Attach the long clear tube to the submersible water pump
and set the pump in the bottom of the water tank.
Push back rubber boot on electrical cord and plug pump
into an outlet or extension cord. Pull boot over cord
connections to help keep water off the plug.
ASSEMBLY
Fig. 7
Fig. 8
LEG
STAND
LOCK
NUT
SHORT
CARRIAGE
BOLT
WATER
TRAY
FRAME
ASSEMBLY
TABLE STOP
BY-PASS
MOTOR
HEAD
ASSEMBLY
CAP BOLT
(SHORT)
CAP BOLT
(LONG)
SLEEVE
WATER
TRAY
FRAME
HEX
NUT
SLIDING TABLE
LOCK LEVER