7
PREPARE FOR CABINET MOUNTING
Mark the hole location at the back of the bottom panel
(Located underneath bottom panel).
ALTERNATE ANCHOR POINTS FOR LOWER LOCKER
If the bottom of the lower locker is close to the floor and prevents
reasonable access to installing the wall anchor and screw below the
bottom panel, two alternate locations are provided close to the lower
end, inside each side panel.
ALTERNATE ANCHOR POINTS FOR LOWER LOCKER
Remove the unit from the rail and install the wall anchors (M) using a 5/16"
drill bit, or drill an 1/8" pilot-hole if a stud aligns with the location.
Place the unit back onto the rail and align the hole with the wall anchor (M).
Install the anchor screw (N) into the wall anchor or pilot hole.
CAUTION: Do not over-tighten screws.
MOUNT CABINET TO WALL
Remove the unit from the rail and install the wall anchor (M) using a 5/16" drill bit, or
drill an 1/8" pilot-hole if a stud aligns with the location.
Place the unit back onto the rail and align the hole with the wall anchor (M) or pilot hole.
Install the anchor screw (N) into the wall anchor or pilot hole.
CAUTION: Do not over-tighten screws.
STEP 9
STEP 10
ALT
MOUNT
POINTS
