RTS User Station MCE-325, Инструкция пользователя

Страница: 19 / 38

Bosch Security Systems, Inc.
Technical Manual
F.01U.193.228 Rev. 13
CHAPTER 2
Installation
Internal Programming and Adjustments
CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electrical
shock do not perform any servicing other than what is included in the operating instructions, unless you are
qualified to do so.
General
Prior to installing the MCE-325, it may be necessary to change some of the internal programming to suit your particular
application. Table 1 on page 21 and Table 2 on page 22 list the functions for the DIP switches and jumpers which are used for
internal programming. Also shown are the default settings were pre-programmed at the factory.
If your application requires settings different from the defaults, you have to remove the top cover of the unit (see Figure 12 on
page 20) and make the required changes. If you do change the internal programming, it may be useful to note the changes for
future reference.
The locations of the dip switches and jumpers are illustrated in Figure 13 on page 23. Dip switch programming is
accomplished by setting switches to the off or on positions. Jumper programming is accomplished using shorting jumpers. By
inserting the jumpers to short the appropriate pins, a function is either assigned or not assigned. Pin 1 of each jumper is
indicated by a square symbol in Figure 13 for reference when making changes. Also, shown in Figure 13 are trimmers for
adjusting the sidetone and speaker dimming levels. Usage of the DIP switches, jumpers, and level trimmers is described in the
following paragraphs.