RTS BTR-80N, Руководство по эксплуатации

Страница: 41 / 90

BTR-80N, TR-80N, TR-82N Operation 39
Lockout
Lockout is used to keep a user from changing any options at the
base station, except local headset microphone gain and volume.
To enable Lockout , do the following:
>
Press and hold UP+DOWN for two (2) seconds to lock
or unlock the base station.

A padlock appears on the status screen if the base is
locked out.
FIGURE 53.
Status Screen with Lockout Active
Copy
Copy allows the user to select a factory-defined group and copy
it to a user-programmed group. This allows a user to edit the
group if desired.
FIGURE 54.
Copy Screen
To use Copy , do the following:
>
Press and hold the SET+DOWN buttons for 2 seconds
in the group/channel select screen (see Figure 54).
1st Use Defaults
1st Use Default s is used to set the base station to Group 01A,
channels 1, 2, 3, 4, and RETAIN any user-defined groups in
memory. It sets the unit to factory-defined parameters.
To set the base station to 1st Use Defaults , do the following:
1.
Press and hold the MENU button while turning on the base
station.
2.
When Factory Setup displays on the screen, release
MENU .
Factory Default
Factory Default is used to set the base station to Group 01A,
channels 1, 2, 3, 4, and ERASES any user-defined groups in
memory. it sets the unit to factory-defined parameters.
To set the base station to Factory Default , do the following:
>
Press and hold MENU + SET + UP+ DOWN for two
(2) seconds.

The screen in Figure 55 displays before the unit
reboots
.
FIGURE 55.
FACTORY SETUP Display