RTRMAX RTM389, Оригинальное руководство пользователя

Страница: 5 / 11

Проверил: Р.Ч./24.03.2015г
Adjusting the Bevel Cutting Angle
Loose the Hex bolt on the base plate along its front side with socket wrench , then Pivot the
machine sideways until the desired cutting angle is set on scale(0~
45°), tighten the hex bolt again.(Fig4)
Switch action(Fig5)
△
,!Caution:
• Before plugging in the tool, always check to see that the tool is switched off. And the switch
trigger can move freely.
1. To start the tool, press the switch trigger.
For continuous running, press the switch trigger then press the lock button..
2. Release the switch trigger to stop the tool.
Replacing carbon brushes.(Fig6)
1. Remove and check the carbon brushes regularly. Replace when the tool occurs obvious
sparks or wear down to the limit mark.
2. Both carbon brushes should be replaced at the same time. Use only RTRMAX brushes
provided.
3. Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes,
insert the new ones and secure the brush holder caps