RTK REpos-8010, Руководство пользователя

Страница: 23 / 32

Digitaler Stellungsregler
Digital positioner
Positionneur digital
RE pos
-8010
19.10.2017 REpos-8010.docx Technische Änderungen vorbehalten /
Technical changes reserved / Modifications techniques sous réserve
page 55
31.4 Configuration parameter
Configuration parameter
# Display Description Parameter Value Function
1 Ainp Analog Input 0-20mA / 4-20mA
0-10V / 2-10V Setpoint Input type current/ voltage
2 SpRv Setpoint Inversion Dir (Direct )
Rev (Reverse) Changes the direction of the setpoint e.g.
4mA actuator spindle extended
or
4mA actuator retraced
+
chapter 34
3 Aout Analog Output Type 0-20mA / 4-20mA
0-10V / 2-10V
Optional
Select feedback signal output type
4 Rinv Feedback signal Inversion Dir (Direct )
Rev (Reverse) Changes the direction of the feedback signal e.g.
4mA actuator spindle extended
or
4mA actuator retraced
5 SplM Split range mode None, High, Low
+
chapter 35
6 SplT Split range Threshold 20…80% Split point
7 Safe Safety Position Off
Open
Close
Actuator position in error mode
e.g. Input signal fault.......
8 DBnd Dead band 0.5…5.0% neutral Zone between operation commands
open ->close or close->open
9 MnTT Minimum Travel Timeout 0……1000s Minimum delay to enter in position error
.
+
chapter 38
10 ClTe Close Tight Enable En (Enabled)
Dis (Disabled) Close Tight Function enabling
.
+
chapter 37
11 ClTB Close Tight Band 0.5….5.0% Close Tight value for open /close limits
12 SpLn Setpoint Linearization Enable En (Enabled)
Dis (Disabled)
Setpoint Linearization with max. 21 Interpolation-
points .
+
chapter 36
13 SL0 Interpolation point 0 (0%) 0….100% Parameters are displayed if SpLn is enabled
.. …… …………………………….. ……………… ……………………………………………………..
………………………………………………
33 SL20 Interpolation point 20 (100%) 0….100%
34 RM.SP Remote Setpoint Fieldbus 0….100% If Fieldbus operation is active, the value of the digital
setpoint received is displayed.
35 RSP.H Remote Setpoint High Limit 0….100% max. Setpoint value accepted from fieldbus
36 RSP.L Remote Setpoint Low Limit 0….100% min Setpoint value accepted from fieldbus
37 PW.GL Password Global Access - 1999….9999 Password for Config and CMD menu access
38 PW.CF Password Config Access - 1999….9999 Password for Config menu only
39 FL.cl Force Local Control En (Enable)
Dis (Disable)
If Enable remote control from fieldbus is inhibited
40 CBus Fieldbus selection None
CAN open
Profibus DP
optional
Fieldbus selection
(Proper optional hardware required)
41 Addr Node Address 1….127 Fieldbus Node Address -> Parameter displayed
only if fieldbus is active
42 Baud Baud Rate (Kbit/s) 20,50,100,125,250,
500,1000
Only for CAN open
Profibus baud rate auto selected
43 MB.AD Modbus Address 1…255 Node Address Modbus
44 MB.BR Serial Com Baud Rate 4800,9600,19200
38400,57600
Baud rate Modbus Communication