Remote Control Processor
XP-6
6
etHeRnet
This RJ-5 port allows connection to a 0/00 Base-T Ethernet network
(LAN) for programming, control and communication with compatible
devices. Network settings such as the IP address are configurable within
Integration Designer
®
.
usb PORt
Used to download programming software or firmware into the XP-6.
eXPansIOn PORt
This RJ-5 port provides a convenient connection for receiving IR signals
from in-wall controllers through an RTI connecting block (CB-8). It also
enables two-way serial communication (RS-85) with in-wall touchpanels
or expansion devices.
Rs-232 PORts
The XP-6 is capable of two-way RS-22 communication and uses industry
standard cat5 cable with RJ-5 termination (568B).
NOTE: RS-22 communication has a distance limitation of 50-00 feet.
CHaPteR 3 | InstallatIOn and OPeRatIOn
DB-9 Connector Pin Out
Pin Signal Signal
Name Description
DCD Carrier Detect
2 RXD Receive Data
TXD Transmit Data
DTR Data Terminal Ready
5 GND Signal Ground/Common
6 DSR Data Set Ready
7 RTS
Request To Send
8 CTS
Clear To Send
9 NC
Not Connected
RJ-5 Connector Pin Out
Pin Signal Signal
Name Description
DSR
Data Set Ready
2 DCD Carrier Detect
DTR Data Terminal Ready
GND Signal Ground/Common
5 RXD Receive Data
6 TXD Transmit Data
7 CTS
Clear To Send
8 RTS
Request To Send
RJ-45 tO db-9 adaPteR PInOut
