Manual: RTI NEO ONE
page 10 / 48
51 - 60
2 dots horizontal
61 - 70
2 dots vertical
71 - 80
3 dots horizontal
81 - 90
3 dots vertical
91 - 100
Circle
101 - 110
4 quarter circle
111 - 120
Test picture
241 - 255
Blackout
9 Zoom
0 - 255
Gobo size
active, if value
of channel 8
between 11
and 110
10 Strobe
0
Strobe off
Strobe effect
1 - 127
Strobe speed
2Hz - 12Hz
128 - 255
Grow effect
256 points - 0
points
11 Rotation
pattern Coarse
0 - 255
Rotation MSB
12 Rotation
pattern Fine
0 - 255
Rotation LSB
13 Grating
Selection
0
No grating
If available
1 - 127
Grating 1
128 - 255
Grating 2
3.
Interlock
(RJ45)
There is an ‚Interlock IN‘ interface on the rear side of the PSU. The Interlock signal is forwar-
ded to the RTI NEO ONE via a data cable (just like the DMX signal).
An interlock connector is provided with the PSU for testing purposes. Use an E-Stop for
your laser shows. If an Interlock / E-Stop is plugged in the PSU, the laser output of the con-
nected RTI NEO ONE devices gets enabled (if key switch is in ‚ON‘ position).
4.
Key Switch
There is a key switch on the rear side of the PSU. Please insert the key into the key switch
and turn it to ‚Laser ON‘ position to enable laser output of all connected NEO ONE devices.
Turn the key to ‚Laser OFF‘ to switch off the devices. Please remove the key to avoid unau-
thorized access.
5.
Display
It is possible to adjust settings directly at the device by means of the integrated display and
the data entry wheel below it: