RTI ATX-2, Руководство по эксплуатации

Страница: 7 / 15

Page 6
90° Adapter Hose
12 inch
Straight Adapter Hose
New Fluid Sight Indicator
Transmission
Fitting
Radiator
12 inch
Adapters
Cooler Lines
CONNECTING TO THE TRANSMISSION SYSTEM
1. Add desired amount of transmission fluid to the new fluid tank through the ATX-2 fill port.
Monitor fluid level in the ATX-2 through the Level Indicator.
2. Locate and disconnect the transmission cooler lines at the most convenient location:
A. At cooler line connecting to radiator usually most accessible if vehicle is not on lift.
B. At clamped rubber hose connection to transmission cooler usually most accessible if
vehicle is on a lift. Cooler is most often in front of the radiator.
C. At cooler line connecting to the transmission usually requires vehicle to be on a lift.
3. Select and install proper fitting adapters to disconnect points. Use closest matching adapter
and o-ring to seal any leaks if exact matching adapter can not be found. In some cases it
may be easier to use one of the open end rubber hose adapters on the disconnected male
fitting on the cooler line then to select the matching adapter.
4. Connect 12 inch adapter hoses to fitting adapters.
5. Connect 10 ft black and red hoses (right side of ATX-2) to the 12 inch adapter hoses.