⚠
ATTENTION:
PLEASE READ THESE TIPS AND WARNINGS BEFORE YOU START THE ASSEMBLY.
☛
Do a quick inventory to make sure the product contains all the parts and hardware.
☛
Missing, damaged and defective parts can be replaced at no cost to you. Please
refer to the CONTACT and the WARRANTY cards included with the product.
☛
If during assembly you find an issue or need clarification, please contact our Customer
Service for assistance. Please refer to the CONTACT card included with the product.
☛
On each step read the instructions and analyze the illustrations thoroughly before
proceeding to do the assembly.
☛
To avoid misalignments, always leave the screws loose and tighten them until all pieces
are positioned correctly.
☛
Do not overtighten or force the screws as they might break, strip, damage the threads
of the holes or get stuck inside the part.
☛
Sometimes the laminate might cover partially or entirely the hole on a panel, but the
hole should still be located under the laminate.
☛
If there is no visible hole for the screw, pass and press the tip of your finger over the
area where the hole should be located to feel the indentation, and once found, carefully
pierce the laminate to reveal the hole underneath.
☛
If the hole seems too small for the screw, first make sure you are using the correct size
of screw, and that it’s been installed in the correct hole. If the hole still appears to be too
small, carefully pierce the laminate to reveal the hole’s actual size.
☛
This unit uses cam bolts and locks. The following page explains how to work with this
kind of hardware.
☛
Make sure you understand which hardware will be used on each step. Using the wrong
size of screw, bolt or pin might cause damage to the panel in which it is being used.
RTA-BC19
P.3
P.3
