ASSEMBLY STEPS
P.4
RTA-2018
P.4
Using the wrench, assemble the casters
②
to the structures
①
L,
①
R in the following
order:
☛
The locking casters
②
L go on the front bottom holes,
☛
The non-locking casters
②
N go on the back bottom holes.
First check and make sure of the correct alignment of the inserts in the back panel
③
, then
use screws
Ⓐ
to assemble it to the structures
①
L and
①
R as shown.
If the inserts are misaligned,
use a flat head screwdriver
to re-align them.
STEP 1
STEP 2
Screws:
Ⓐ
6x45mm
4
Pcs
L
N
Panel
③
comes with metal inserts on its interior face, they look like screws but are nuts
pre-aligned to receive the screws. Sometimes misalignments occur, and you will have to use
a flat head screwdriver (not included) to turn and align the inserts as shown below.
YES √
NO X
The middle and
lower bars face
towards the inside.
Locking at front
Non-locking at back
