8)
Remove Delimiters from ASCII Message:
If checked, the gateway will remove all delimiters that
have been configured before sending it to the other protocol.
9)
ASCII Parsing (Optional):
Additional parsing can be performed on the string before being passed
to the other protocol. See the ASCII Parsing section for more information.
10)
Gateway Hold Msg Timeout:
Enter the amount of time (in ms) to wait before sending a new
message to the other protocol.
11)
Queue Full Behavior
: Select which message to discard when the Queue is full. Once the Queue
is full, the gateway will discard either the oldest or newest message (Only used if Gateway Hold
Msg Timeout is non-zero).
12)
Queue Size
: Select how many complete messages the gateway will hold before starting to
discard (Only used if Gateway Hold Msg Timeout is non-zero).
Transmit Data
This is configured to transmit data from the gateway into the ASCII device.
Use the following setup fields to help the 460 transmit an ASCII message.
1)
Enable
: Check this box for moving data from the Gateway to the ASCII device.
2)
Max Message Length
: Enter the max number of characters that can be transmitted by the
gateway.
3)
Transmit Timeout:
Enter the amount of time (in ms) that the gateway waits before sending an
ASCII message (0 Sends Immediately). If the data has changed before the time expires, the
gateway immediately sends the message to the ASCII device.
4)
Delay Between Messages:
Enter the amount of time (in ms) that the gateway waits before
verifying a Change of State of the ASCII message OR will start the Transmit Timeout.
5)
Number of Start Delimiters:
Select the number of delimiters that will be added onto the
beginning of the ASCII string.
Real Time Automation, Inc.
33
1-800-249-1612
