RST METEO PROJECTION 705, Инструкция по эксплуатации

Страница: 25 / 28

"+ ch/src" button
•
When the main station searched remote sensor, press this button, it
can exit the receiving mode and enter the radio controlled receiving
mode.
• When it is in normal mode, press and hold this button for 3 seconds, it
can search remote sensor mode manually, and it will clear all the
data in the original channels.
•
If the main station login above two channels, press this button, you
can choose different channels display or enter auto scroll mode.
•
When setting the calendar or alarm time, press "+ ch/src" button , it
can adjust the setting item up, add 1 by each press. Hold this button,
it can increase quickly.
"- memory" button
•
Press "- memory" button to show the maximum indoor and outdoor
temperature.
"MAX" is shown on the LCD
•
Press "- memory" button again to show the minimum indoor and out-
door temperature.
"MIN" is shown on the LCD.
• When the "max" or "min" is showing on the LCD, press and hold "- mem-
ory "button for 3 seconds to clear the recorded maximum and minimum
reading.
•
When it is in the receiving of RCC, press "- memory, it can exit the
receiving mode manually. In the normal mode, press and hold "-
memory" for 3 seconds, it will enter RCC receiving mode by hand.
• When setting the calendar or alarm time, press "- memory" button , it
can adjust the setting item down, reduce 1 by each press. Hold this
button, it can reduce down quickly.
temperature and air pressure trend display
After you insert batteries the weather station measures the current tem-
perature and air pressure. The trend is not shown on the LCD. When it
appears
, it means that temperature and air pressure will have the
trend to ascend, and when it appears , it means that temperature and
air pressure will have the trend to descend. If without these two symbols, it
indicates that the temperature and air pressure are in stable .
weather forecast setting
•
Press and hold "meteo set" for 3 seconds, it enter corresponding air
pressure parameter setting, when the setting item blinks, press
or
to change the current parameter. Press "metero set" to confirm
each setting and enter next setting item, the order is as follows: cur-
rent air pressure value, current weather pattern, weather forecast
sensitivity. It will automatically exit the setting mode at 20 seconds
with any adjustment and keep the setting value.
25
manual32705-707-2011:32705-707Manual-2011 25.08.2011 12:37 Page 25