RST IQ555, Инструкция по эксплуатации

Страница: 16 / 28

Note: Please note the polarity when inserting/replacing batteries in the unit, failure to do so
may result in permanent damage. Use good quality Alkaline Batteries and avoid recharge-
able batteries.
1 Insert two AAA batteries into the remote sensor. After the remote sensor is powered up, the sensor will trans-
mit weather data every 8s for 8 times. After this learning period is over, then the transmitter will transmit every
48s.
2 Insert two AA batteries into the weather station. When the base station is powered up all LCD segments will
light up for about 4 seconds before it enters into learning mode to learn the sensors security code. Every time
the remote sensor is powered up (for example after a change of batteries), a random security code is trans-
mitted and this code must be synchronized with the base station to receive weather data. Thus if battery
change happened on remote sensor side, then the base station must be power up again to re-learn the
transmitter.
3 Wait 3 minutes or until the outdoor temperature is displayed in the weather station. Do not press any keys
before outdoor sensor data received. The wireless weather station can receive up to 3 temperature sensors.
If you have purchased additional remote sensors, repeat step 1) for all extra sensors. However, ensure that
you leave 10 seconds in between the reception of the last sensor and the set-up of the following sensor. The
wireless weather station will number the sensors in the order of set-up, i.e. the first temperature sensor will
have the temperature displayed with 1.
4 Mount the units, ensuring that the receiver can still pick up the signal from the transmitter. To measure outdo-
or temperature, place the transmitter outdoors. It will transmit the temperature from its location.
Note: DO NOT PRESS ANY KEY on the base station until the first set of data is display on the LCD.
This ensures that the base station has synchronized with the sensors and that the system is now
functioning. If a key is pressed before the weather station receives the temperature signal,
you will need to follow the battery installation procedure again. Please wait 10 seconds befo-
re re-insert the battery again to make a proper reset for both transmitter and receiver.
Note: Please participate in the preservation of the environment by properly disposing of all
used-up batteries and accumulators at designated disposal points. Never dispose of bat-
teries in a fire as this may cause explosion, risk of fire or leakage of dangerous chemicals
and fumes.
RST02555 16
Installing the Batteries
02555Manual-2011:02555Manual-2011 25.06.2011 14:59 Page 16