![RST Instruments MEMS Digital Inclinometer System Скачать руководство пользователя страница 48](http://html1.mh-extra.com/html/rst-instruments/mems-digital-inclinometer-system/mems-digital-inclinometer-system_instruction-manual_1497015048.webp)
MEMS Digital Inclinometer System with Android
Instruction Manual
ICM0099A
43
Appendix A
C
HANGING THE
B
ATTERY
(
FOR REELS WITH
SERIAL NUMBERS UNDER
2500)
Batteries inside reels with serial numbers under 2500 may be removed for recharging. The
reel uses a 7.4V lithium-ion camcorder battery. The system comes with a battery housed
inside the reel and a charger. Adapters are supplied to allow the charger to function in a
vehicle (12V DC), or 110-240V AC power (see
). Reel batteries should be kept at a
state of full charge whenever the probe is not in use.
To remove the battery, simply unscrew the cap off the reel hub by turning it counter-
clockwise (Figure 30
).
Figure 30
– Battery Removal / Installation
Remove the battery and place on the Mach 1™ Speed Charger.
Mach 1 Speed Charger Operating Instructions
Status LED’s
Together, the three LED’s on the front of the Mach 1 charger will indicate the status of the
battery and the charger. The descriptions and diagrams included in the following sections
describe the various indicators and their meaning.
Standby Mode
Without any battery installed, the charger will flash the LED on the left, marked
MED
,
indicating that the charger is standing by and waiting for a battery to be connected.
STANDBY FLASHING
OFF
OFF
MED
HI
MAX
Figure 31
– Standby Mode
Once a battery has been properly connected to the charger, it will determine the status of the
battery and begin the proper phase of the charging cycle. There are 3 phases to the charge
cycle. The battery may be removed during any of the charging phases without harm to the
battery or charger unit.