DT2306 Potentiometer Data Logger Manual
ELM0075B
Page 3
3.3
P
OTENTIOMETER
C
ONNECTION
There are five cable glands on the exterior of the DT2306 logger. The following
instructions detail the steps necessary to loosen the glands and insert and connect
the cable.
CAUTION:
A
VOID OPERATIONS WITH THE LOGGER COVER OFF IN RAIN OR SNOW
.
D
O NOT ALLOW RAIN OR SNOW TO ENTER THE ENCLOSURE
.
D
O NOT INSTALL IN FLOODABLE LOCATIONS
.
T
HE LOGGER IS RAIN
-
TIGHT ONLY AND NON
-
SUBMERSIBLE
.
NOTE:
T
HE PICTURES IN THIS SECTION ARE INSTRUCTIONAL AND MAY FEATURE A
LOGGER OTHER THAN THE
DT2306
TO ILLUSTRATE THE INSTRUCTIONS
.
1
Loosen the cable gland using two 20 mm wrenches. Hold the bolt in place with
one wrench. Loosen the cap with the other wrench. Refer to Figure 3-1 for proper
wrench placement.
Refer to Figure 3-2 for the cable gland nut wrench placement.
CAUTION:
E
NSURE THE ENTIRE NUT BODY DOES NOT LOOSEN
.
L
OOSEN ONLY THE
GLAND
.
F
IGURE
3-1
L
OOSEN THE CABLE GLAND USING TWO
20
MM WRENCHES
