RSP P1301A, Руководство по установке и обслуживанию

Страница: 16 / 36

16 M0627-1 version 3.3
Check servo power sockets Check that the areas around the
sockets are clean. For cleaning
and lubrication see section 3.2.3.
Check that the sockets are not
worn-out or damaged. For
replacing the signal or servo
power interface see section 4.3.5.
NOTE! When interface options,
P1307, P1356, P1354 are used!
Check high voltage socket Check that the area around the
high voltage socket is clean. For
cleaning and lubrication see
section 3.2.3.
Check that the high voltage socket
not is worn-out or damaged. For
replacing the high voltage
interface see section 4.3.5.
NOTE! When high voltage
interface, P1322, is used!
Check cables Check cables for damages and
squeezing, replace if damaged.
Check tool changer in general Check the tool changer for
damages. For replacement see
section 4.1.
3.2.2 Visual inspection and cleaning of tool attachment
The following maintenance activities should be carried out on the TA every 2
nd
week.
Action Note
Check holes for the guide pins Check that the guide pin holes are
greased. For cleaning and
lubrication see section 3.2.4.
Check that the guide pin holes are
not worn-out or damaged. For
replacing the tool attachment see
section 4.2.