RSP P1001, Руководство по эксплуатации продукта

Страница: 28 / 38

28 M0109-1 ver 2.2
4.3 Cleaning
4.3.1 Cleaning and lubrication of swivel with tool changer
Action Note
1 Clean locking balls Wipe the locking balls with a
cloth.
2 Check locking balls Check each ball to make sure it
moves freely. Additional cleaning
may be necessary to free any
balls stuck in place.
3 Lubricate looking balls Apply a small amount of grease
(Molykote BR2Plus) on the
locking balls.
NOTE! It is important that this is
done or there might else be a
risk that the tool attachment
jams.
3 Clean signal pins (TC5-4E only) Clean only the contact surfaces!
NOTE!
Avoid cleaning solvent in the
housing.
4 General cleaning Clean the swivel with tool
changer in general.