RSP P0108A, Руководство по установке и обслуживанию

Страница: 22 / 28

22 M0412-1 ver 3.0
4.2 Replacement of tool attachment
Action Note
1 Safety Read the safety section 1.2 .
2 Undock tool Undock tool attachment, with tool
mounted, in a safe and fully
supported position for dismounting.
3 Release connections (electrical
versions only)
Disconnect electric power and
signals.
NOTE! Handle contacts with care,
as they are sensitive to mechanical
damage. Make sure that no dirt
enters the contacts.
4 Dismount hoses Dismount the air hoses from the
tool attachment.
NOTE! Make sure that no dirt
enters the air hoses.
5 Remove screws Remove the screws holding the
tool attachment to the tool.
WARNING! The tool attachment is
heavy and may cause personal
injury and equipment damage if
dropped.
6 Dismount tool attachment NOTE! A guide pin is mounted
between the tool attachment and
the tool.
7 Clean the flange at the tool
8 Mount tool attachment Follow instructions in section 2.2 .