RSP P0108A, Руководство по установке и обслуживанию

Страница: 6 / 28

6 M0412-1 ver 3.0
1.2 Safety
1.2.1 General
The integrator installing the swivel tool changer into the system must follow the safety demands
stated in standards and provisions applicable in the country where the swivel tool changer
system is to be installed. The products are all prepared for CE-certification.
The user of the Robot System Products swivel tool changer is responsible that law and
directives applicable in respective countries, with regards to safety, are followed. The user is
also responsible to guarantee that all safety devices are installed correctly.
WARNING!
Never carry out service work on a robot that has not been taken out of operation.
See safety information for the robot.
WARNING!
Only perform work on tools attached to the swivel tool changer if the air pressure is
safely switched off.
WARNING!
Be aware that swivel tool changers and tool attachments are heavy and may cause
personal injury and equipment damage if dropped.
NOTE!
The swivel tool changer shall always be in locked position, also when empty, to avoid
unexpected locking if air pressure is lost.
WARNING!
Electric signals and power must be disconnected/switched off when docking the tool
attachment. This is to prevent sparking between signal pins and tool attachment.
1.2.2 Explanation of warnings
The warnings in this document are specific to the products in this manual. It is expected that the
user also pay attention to certain notifications from the robot manufacturer and/or the
manufacturers of other components used in the installation.
WARNING!
The warning sign will make you aware that a situation could result in potential
serious injury or damage to equipment.
NOTE!
The note sign will alert you about something important to consider.