RSP P0010A, Руководство по эксплуатации продукта

Страница: 15 / 44

M0001-1 version 2.0 15
2.2 Pneumatic diagrams
NOTE!
“T” stands for installed tool change valve and “D” for installed directional
valve
s, “t” stands for slots inteded for tool change valves, “d” for slots intended for
directional valve while “t/d” stands for slots which can be used for either a tool
change or a directional valve.
Installed valves in small valve units
Small valve
unit Installed valves Pneumatic
diagram
Valve V1 Valve V2 Valve V3 Valve V4
P0010A d d d t
Pne0214-010
(section 2.2.1)
P0011A D D - T
Pne0214-011
(section 2.2.2)
P1008 d d d d
Pne0214-008
(section 2.2.3)
P0012A D - - -
Pne0214-013
(section 2.2.4)
P0013A D D D -
NOTE! Valves are not included in P0010A and P1008. P0010A are intended for
installation of up to three directional valves and one tool change valve. P1008 are
intended for installation of four valves when no tool change function is required.
Installed valves in extended small valve units
Extended
valve unit Installed valves Pneumatic
diagram
Valve V1 Valve V2 Valve V3 Valve V4 Valve V5
P0026 d d d d t/d
Pne0214-026
(section 2.2.5)
P0027 D - - - T
Pne0214-027
(section 2.2.6)
P0028 D D D - T
P0029 D D D D T
P0035 D D - - -
Pne0214-035
(section 2.2.7)
P0036 D D D D -
P0037 D D D D D
Pne0214-037
(section 2.2.8)
NOTE! Valves are not included in P0026. It is intended for installation of up to five
valves out of which one can be a tool change valve.