Main Power Switch
-
This will normally be left on. However, when connecting and disconnecting cables
to the Speedwoofer, first make sure the main power switch is off. When switched on, your Speedwoofer
will go into standby mode (red light) until it receives an audio signal (when the auto power switch is set to
on). Then, the light will turn from red to blue or green (depending on version of Speedwoofer). When the
Speedwoofer stops receiving a signal, it will return to standby mode after approximately 20 minutes. To
use the standby function, the auto power switch must be set to on.
AC Receptacle
-
Receives the power cord and AC power. This is where the fuse is stored.
Dual Speedwoofers
It
’
s easy to run 2 Speedwoofers (your neighbors will wish it was harder). If your audio source (receiver or
amplifier doesn
’
t have dual subwoofer outputs), simply connect an RCA cable from the first Speedwoof-
er
’
s Line Out to the second Speedwoofer
’
s Line Ins (a single cable for home theater or a stereo cable for 2
channel stereo). Now, both subwoofers will play when the first Speedwoofer receives a signal. This meth-
od will only work when the first subwoofer is connected either by line input or speaker level input.
Specifications
Frequency Response: 21
-
200 Hz+/
-
3db
Overall Frequency Response: 18
-
200 Hz (Room dependent)
Amplifier Power: 400 Watts/RMS (1,000 or more Watts Peak Dynamic Power) Note: Peak power specs
are not regulated and isn
’
t an honest way to rate power.
10" Aluminum Frame High–Excursion Woofer with Massive Double Magnet Structure
Compression Guide Tuning Technology
Wireless Operation with Optional Wireless Transmitter
Wireless range: approximately 50 feet.
Dimensions: 16"H x 15"W x 17 3/4" D (Including AC Cord) Weight: 45 lbs
.
Care And Maintenance
Caring for your RSL Speedwoofer is relatively easy and does not require much on your part. We have
listed the most important dos and don
’
ts below.
1.
Clean your subwoofer using a soft, moist cloth (Windex or water is recommended), preferably micro-
fiber or lint
-
free. Do not put your subwoofer in the washing machine or dish washer.
2.
Be very gentle when cleaning the front of your subwoofer, trying not to put pressure on the woofer
itself.
3.
Be careful with liquids or beverages near your Speedwoofer. It does not play better when wet. Don
’
t
place flowers or plants that require watering on top of the subwoofer. Watering your Speedwoofer
will not make it grow.
4.
Please keep your Speedwoofer away from direct sunlight and heat sources. Leave a few inches of
room behind the Speedwoofer for air flow to the amplifier.
5.
If you operate the subwoofer with the grille off, please make sure that the woofer does not come in
contact with anything as it can be damaged.
6.
Wires can loosen over time. Periodically check to make sure all connections to the Speedwoofer are
tight.
7.
Your Speedwoofer may not be used as a flotation device.
3
Input Voltage
-
Is normally set for use in the U.S. and Canada at 110 Volts
. If your country's AC voltage
is 230
-
240 Volts, you must change this setting before using the Speedwoofer. You must also change the
fuse to a 2.5 amp fuse. See the back of the subwoofer. Failure to do this will damage the subwoofer
and is not covered under warranty.
