Sanitisation Guide
NOTE: Before beginning the sanitation process please ensure that water is turned off at the rnains and refer to the MSDS document
for further information. Use bioguard hand gel and ensure gloves are worn.
@
@
Briefly press cold/ambient
dispense button to release
internal water pressure frorn
the machine.
Turn on incoming water, allow
service cartridge/doser to fill.
When the external cleaning
(rninirnurn 5 minutes) is
completed, flush the machine
using the cold button with
clean water until the dispense
water runs clear. Repeat
briefly with the ambient
button (and sparkling button if
present).
Rernove the existing filter.
Dispense water using the cold
button until the water appears
pink. Briefly press the ambient
button too. Repeat with
sparkling button if present.
Turn off water and rernove the
service filter. Retain service
filter for reuse.
Borg & Overstrom
Install & Operation Manual
Add 25 rnl of Bioguard
Internal Sanitisation fluid to a
clean and ernpty service filter
cartridge.
Leave the solution inside
machine for sanitisation
to take effect (rninirnurn 5
minutes) while thoroughly
cleaning the machine
externally, pay particular
attention to the dispense
faucet and button controls.
Fit new filter. Turn on incoming
water supply.
l l
Connect to machine.
Rernernber to include the drip
tray. Ernpty the Waste Overflow
��rn a�fl�h�m�h��a
srnall amount of sanitisation fluid
if needed.
Pre-flush the new filter to waste
using the ambient button (and
sparkling button if present)
until the water appears
clear and is free of air. Flush
through a small amount of
water to check all functions.
GB
