4455 White Bear Parkway, Suite 700
White Bear Lake, MN
55110
USA
T o l l F r e e : 8 7 7- 2 0 6 - 5 8 0 0
F a x : 6 51-76 2 - 4 6 9 3
www.videofied.com
© 2007 RSIalarm™ Videofi ed
®
is a Registered Trademark of RSIalarm™.
S
2
View is a registered trademark of RSIalarm™. Specifi cations subject to change without notice.
Mounting
>
Use proper tools and hardware for mounting the unit.
>
Mount outdoors under eves to help prevent direct contact
from
elements.
>
Mount on front of structure where strobe light is clearly
visible to responding authorities.
Regulatory Information
FCC Part 15
This device complies with FCC Rules Part 15.
Operation is subject to the following two conditions:
1.) This device may not cause harmful interference and,
2.) this device must accept any interference that may be
received, including interference that may cause undesired
operation.
Changes or modifi cations not expressly approved by RSIalarm,
Inc. can void the user’s authority to operate the equipment.
Specifications
Panel Compatibility
V-6000
Operating Frequency
915 MHz. 25 frequencies
Radio type
Spread Spectrum Bidirectional RF
Power Requirements
Four 1.5 V Alkaline batteries
Battery Type
D size alkaline
Power Output
105 dB @ 1 meter
Operating Temperature
-13° - 158° F (-25° - 70° C)
Maximum Relative Humidity
70%, non-condensing
Dimensions
(LxWxD): 9 in. x 6-1/2 in. x 3 in.
(227 mm x 166 mm x 80 mm)
Weight
31 oz./880 g (without batteries)
UL Listings
1023 (applied for)
1
Remove batteries.
2
Hold unit up against
mounting surface and
mark the three
mounting
holes.
3
Drill pilot holes
and install anchors
where
needed.
4
Place unit on mouning surface so mounting holes
line up with pilot holes/anchors and secure unit with
appropriate
screws.
5
Install batteries, observing correct polarity.
6
Attach front cover.
Mounting Holes
I N S T A L L A T I O N I N S T R U C T I O N S
Exterior Siren/Strobe Model SE 650