RS PRO ICA32N, Инструкция по эксплуатации

Страница: 10 / 13

9
3. Press the lever to open the jaw and place the jaws round the conductor whose current you wish to measure.
Release the lever and make sure the jaws are properly closed. Then read off the measurement from the
multimeter display.
3.2 Measuring d.c. currents
1. Use the slide switch to set the adaptor to the highest range you will need (600A or 100A).
2. Plug the output connectors (red and black) into the input sockets of a digital multimeter and set the multimeter to
an d.c. voltage range of 200mV or 2V.
3. Adjust the zeroing potentiometer to give a reading of "0" on the multimeter display.
4. When measuring d.c. currents, you will get a positive measurement when the current in the conductor enclosed by
the jaws is flowing upwards, as shown in Fig.2.
5. Press the lever to open the jaw and place the jaws round the conductor whose current you wish to measure.
Release the lever and make sure that the jaws are properly closed. Then read off the measurement from the
multimeter display.