RS PRO 908WHB-3, Инструкция по установке и эксплуатации, Страница: 3 / 8

3
I
NSTALL THE THERMOSTAT
ATTACH THERMOSTAT BASE TO WALL
B ase
Screw for mounting thermostat to wall
Figure 3
Fixing screw
C ontrol panel
1. Remove 2 screws from the bottom of thermostat.
Gently pull the control panel straight off the base.
Forcing or prying on the thermostat will cause
damage to the unit.
2. Connect wires beneath terminal screws on power
supply module using appropriate wiring
schematic. See figure 4
3. Push power base into wall.
4. Using two mounting screws mount the power
base to the wall. Place a level against bottom of
base, adjust until level, and then tighten screws.
(Leveling is for appearance only and will not
affect thermostat operation.)
5. Replace control panel on the power base and fix
power base and control panel by removed two
screws in item 1
WIRING DIAGRAM
1 2 3
2 30V A C
T 2 T 1
2 30 V A C
3 2 1
25 0V A C
8A
P um p or valve
R elay
250V A C
8A
Figure 4
CHECK THERMOSTAT OPERATION
The unit will be controlled via air sensor in the thermostat and the thermostat will determine to
activate/deactivate heating system by comparing set temperature with room temperature. Press
▲
to
adjust thermostat setting above room temperature 1
℃
in fast heating mode or 3
℃
in slow heating mode,