RS PRO 187-5320, Руководство пользователя

Страница: 16 / 37

16
rspro.com
DRAINAGE
When the unit is operating in Cooling or Dehumidify ( DRY) mode, humidity extracted from the
air is collected in an internal tank. If the tank reaches full, the compressor and motor cut out
automatically. At the same time, the “Water Full” indicator comes on. An alarm will also sound.
When the tank is full, carry out the following instructions:
1. Turn off the air conditioner and avoid moving it
when full.
2. Position a container (a water tray for example)
underneath the drain hole.
3. Remove the drain knob & rubber plug from the
drain hole and allow the water to drain out.
4. When the container is almost full, replace the
rubber plug in the drain hole and empty the
water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the drain
knob firmly.
7. Switch on the unit - the full water or compressor
operating indicator should not be flashing.
FIG.21
Should you prefer to use the appliance without having to empty the tank every so often, p
roceed as follows :
• Remove the drain knob and rubber plug and
retain for future use.
• Connect the drain tube supplied to the water
outlet as shown and locate the other end into a
drain.
• The drain tube may be extended by adding an
extension tube and using a suitable connector.
FIG.22
FIG.23
Please note
1. The drain must be at a lower level than the drain
hole on the unit.
2. Flashing ‘Water Full’ indicator will not function in
this mode of drainage.
3. If you want to extend the water tube, you can
connect it with another tube (OD: 18mm). *The
extended tube is NOT supplied along with the unit.
FIG.24