RRD 2006 kite, Руководство пользователя

Страница: 7 / 10

Assemble the bar on Type
wave 2
The span line (available only on
type wave 2).
One of the main problems with
other kites with 5th line safety
systems is that when the kite
crashes, the 5th line can wrap
around the kite inhibiting the
kite to relaunch or fly properly.
The RRD Anti-Fool Bridle
System on the kite prohibits
the lines from inverting and the
5th line becoming tangled
around the kite. The span line
is tangle with the fifth line bri-
dle on the kite.
-Undo the span-line from the
fifth line bridle.
-Connect the Front lines on the
span line's end.
Pass the span on line on the
fornt tips shackle.
Important:
- The red ball has to be
always between the rear
pigtails and the shackles
(Photo 5.9)
Connect the bar as showed in
Diagrams
Note: Too much weight is better than too little. A loose kite can endanger others down
wind.
Carrying your Kite
Always carry your kite upside down by the center of the leading edge with the kite facing
into
the wind. Carrying your kite in any other way can result
in loss of control of the kite and may create a hazard for those downwind.
Deflating the Leading Edge
To deflate the leading edge, undo the Velcro on both of the valves on the center of
the leading edge and remove the valve caps. You may also choose to use the
wingtip deflation valve for quick and easy roll-up deflation of the leading edge.
6. RRD Control Bar components:
Standar Bar
Reduced Diameter 5-line bar
Quick Release Sheeting Loop
Removable Sheeting Loop Shackle
Spin-able 5th Line Safety Leash attacchment
Depower clam cleat (type 7- Type hir)
Depower trimm with 5th line trimmer (type Evo)
Quick Grab Depower Loop
EVA Bar-End Floats
Handle Pass Leash O-ring on Sheeting Loop
Adjustable 5th line
25m Flying Line Set
RRD Standard Bar Set up
Type Evo
5th Line Tuning Setup
With the new 2006 bar is possible tune the 5th line in case the wind increase suddenly.
Open the neoprene Cover on the back of the webbing
Use the Clam Cleat fixing the 5th line.
The kite will be depowered hanging
on the fifth line.
Type 7 and Type Hir
Depower lenght tuning
With the type 7 /thir bar is possible
adjust the depower lenght
Open the Neoprene cover on the clam
cleat (Photo 6)
Adjust the depower lenght
Move the back lines according to the
front lines
for Type 7 & Type Hir
Attention:Front lines
11cm shorter than back
lines; DePower lenght 15Cm (Base set up)
14 7
6
Red
line
Red
Ball
Blue
Line
Green
line
5.9