
www.rplighting.com | 4931 Paseo Nel Norte NE, Albuquerque, NM 87113 | 800.937.6925
Remote Control Operation
Learning Process
RP.03252022
Turn light ON/OFF.
Timer Function:
1H
The fan will turn off after 1 hour.
2H
The fan will turn off after 2 hours.
4H
The fan will turn off after 4 hours.
8H
The fan will turn off after 8 hours.
Press and release this button to turn off fan.
Press this button to set fan wind direction up or down
.
NOTE
: It will take a few seconds for fan to slow down and change rotation direction.
1 = Highest Speed
2 = High Speed
3 = Medium Speed
4 = Low Speed
5 = Lowest Speed
LIGHT
ON/OFF
FAN
OFF
1
4
2
3
5
F/R
Summer Mode(Forward)
- Fan runs counterclockwise.
Airflow provides a downward cooling breeze.
Winter Mode(Reverse)
- Fan runs clockwise.
Airflow will force warm air downward without a noticeable breeze.
Check to see that all connections are tight, including
To avoid the risk of fire or shock, make sure the electrical wires
are completely tuck inside of the outlet box and not pinched
between the ceiling and canopy.
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan unless blades are completely installed in place.
WARNING
WARNING
Step 1: Install two(2) AAA Alkaline (1.5A) batteries(NOT INCLUDED).
Step 2: Turn on the power on the fan, within 30 seconds turn the transmitter toward the receiver,
press
“FAN OFF”
button and hold for 3-4 seconds, once the receiver has detected the frequency, the receiver will make
”Beep sound”, the digital paring is done and you can;
a. Control the fan with this transmitter.
b. Re-match two ceiling fans with one transmitter with the same process.
If the fan is not responding to the transmitter, turn the power off to fan and turn it back on again and within 30 seconds repeat Step-2.
The digital paring will not function 30 seconds after the receiver is powered on.
NOTE
: After the AC power is on, do not press any other button on the transmitter before doing a digital paring.
NOTE
:
Remove batteries if not used for a long period of time to prevent damage to the transmitter.
NOTE:
When controlling two fans simultaneously, the installation distance between two fans must not exceed 49 ft.
Insert the receiver into the mounting bracket
and store all wires neatly. Install the canopy
to the mounting bracket using screws provided.
RC-7,RC-9
DC CEILING FAN RF REMOTE CONTROL
FOR FAN MODELS: 1070, 1080
INSTALLATION AND OPERATION INSTRUCTIONS
1
4
2
3
5
OFF
FAN
1H
2H
8H
4H
F/R
LIGHT
ON/OFF
Setting up when the fan turn on.
Mount the transmitter holder onto the wall
using screws provided.
Place the transmitter into the holder.
Operation buttons on the panel of the transmitter.
Waterproof Gasket
Mounting
Bracket
CEILING
Canopy
Waterproof Gasket
placed between
Mounting Bracket
and Ceiling
Receiver