-5-
B. To Pre-Rinse, Rinse and Clean the Inside of the Unit
This water dispenser should be rinsed, cleaned and drained prior to use.
Before cleaning, ensure that the unit is OFF and the unit is unplugged
.
1. Remove the top cover by twisting it counter-clockwise and then lift it up.
2. Pour about 2L of water into the top of the unit where the bottle would be placed.Let the water settle for about 2 minutes.
3. Plug the water dispenser into an electrical outlet and turn the power switch ON. Wait about 1 hour for the water to reach its optimal water temperatures.
4. Unplug the water dispenser.
5. Dispense the water from both the hot and cold water taps (about equally).
6. The water dispenser is now ready for use.
C. Storing the Water Dispenser
If the water dispenser is not to be used for an extended period of time, then proceed as below. Before storage.
• Unplug the power cord from the electrical outlet.
• Drain the water through the drain cap underneath the water cooler base
• Store the water dispenser in an upright position
PROBLEM
SOLUTION
Water is not flowing from hot or cold water tap
Water temperature is not cold enough
When a bottle is first installed, it may require you to hold the tap down for up to 30 seconds for water to begin flowing.
· The water dispenser does not have the correct clearances from the wall.
· Too much water has been dispensed within a short period of time.
· Allow time for the cooling system to recycle. The room temperature is too hot (>25°C) or the room is too humid. Find a
cooler location to place your water cooler.
Check to ensure that the water dispenser is on a level surface.
Vibrations
Water leak from bottom of the water dispenser
The drain plug underneath the water dispenser has become loose. Tighten the drain plug securely. Bottle may have a small
pin hole leak. Remove the bottle and drain water from the underneath drain plug, and then try a new bottle.
Water leak from the hot/cold water taps
Water taps maybe loose. Tighten the leaking tap slightly by turning it clockwise.
The water dispenser needs to be pre-cleaned or rinsed.
Water tastes ‘funny’
Condensation on the inside of the water bottle is normal. It occurs when the temperature inside the bottle is different to
outside of the bottle.
Water bottle condensation
TROULBLE SHOOTING
